BISON WAVE Adhesive (30g)

A PVC-only adhesive used for repairs and adhesion of parts.(Can also be used for zephyr boats).The bonding work is very easy because you only need to apply it 3 times and stick it together."Adhesion work procedure"*Be sure to inflate the parts when bonding and deflate the air when repairing holes.Example: When bonding parts : 1. Clean the area to be bonded and dry it. *If oil etc. is attached, wash with neutral detergent and rinse thoroughly with fresh water.2. Put parts on the area to be glued and draw a border with chalk or pencil.3. Please mask with tape on the outside of the edging line. * Even if the adhesive squeezes out, it will be finished neatly.4. Apply thinly and evenly with a brush on the bonding surface between the hull side and the parts.5. Let it dry for about 2-5 minutes.6. Apply again thinly and evenly on the adhesive surface of the hull side and parts with a brush etc.7. Let it dry for about 2-5 minutes.8. Again, apply thinly and evenly with a brush etc. to the bonding surface of the hull side and parts.9. Let it dry for about 5-10 minutes.10, after drying, please stick together. To prevent air from entering the adhesive surface, use a spatula with a rounded tip to push strongly from the center to the outside to crimp it.11.Let it dry for 24 hours.