DAIICHISEIKO Kyuban Line Markey

Fully secured with a super strong suction cup.The Line Markey can be attached to all flat parts, including tables, windowpanes, and car bonnets.A rotation system with automatic kink elimination, in which the spool rotates when the line is wound on the reel.Eliminating frustration resulting from kinks and making the line last long.OK to change lines on the fishing spot. Ideal for lures that use thin lines and for PE lines that may kink easily.Bait reels are available as well.Size (including cover): 182 ? 160 ? 88 mm (horizontal mounting); 162 ? 178 ? 88 mm (vertical mounting).Spool maximum installation width: 80 mm; maximum diameter: 125 mm* Up to six coupling spools with a diameter of 123 mm (e.g., Yotsuami Ultra Dyneema) can be attached (for a distance of 600 m). Adsorption method : 1) Cleanly wipe off the dirt and moisture on the adsorption surface to be used, such as that of a table or car.2) Attach only the suction cup.3) Put a washer on the bolt of the suction cup and put the cover.4) Select horizontal or vertical mounting.* The internal nut rotates.5) Tighten the bolt of the suction cup and the internal nut while turning the main part.* The inside of the suction cup pulled with the bolt becomes a vacuum state and powerfully adsorptive. Adsorption method from the state where the main body, cover, and suction cup are set.Loosen the bolt and body of the suction cup as much as possible, press the main body strongly against the suction surface, then turn and let it strongly stick.Winding method : 1) Follow the adsorption method and let the product stick to the desk or car.2) Pull out the fixing pin and rotate it 90 to secure the rotating holder.3) Set the spool. (In order to suppress rotation blur, sandwich the asymmetric arms A and B according to the unevenness of the center of the various spools)* Loosen the adjustment screw and open the arm.* Tighten the adjustment screw to close the arm.4) Adjust the tension.* Tightening the adjustment screw will increase the tension.5) Tie the line to the spool of the reel attached to the rod.* Possible to wind up the line only with the reel as well.6) Pull out the fixing pin and rotate it 90 to free the rotating holder.7) Put the rod on the rod receiving part.* The stability will improve.8) The setting is completed at this stage. Wind at the same speed from beginning to end at once.