DAIWA Senyo Spool Tsuki PE Line Changer

Even more convenient! PE line changer body and dedicated spool set

A dedicated spool (black) is set on the PE line changer.
Can also be used for line rewinding, inside out, storage, and salt removal.
Commercially available thread spools can also be installed using the attached bolts and nuts.

PE line changer : 

Body dimensions : 47mm x 50mm x 150mm (height)

Body weight : Approximately 95g (excluding batteries)

Specification : Batteries: 2 AA batteries
* AA batteries are not included.
Length that can be pulled out at one time: Approximately 150m (PE line No. 1)

Spool : 

Body dimensions : Approximately φ60mm × 41mm

Body weight : Approximately 19g

Specification : Reference thread winding amount: PE4 No. 300m
Attached bolt, nut: M8

■ Usage example

Winding method : 

1: Insert AA batteries correctly according to the instructions on the main unit.

2: Push the spool in the direction of the arrow until you hear a click, and the spool arm will open.

* Close the spool arm when not in use.
If you leave it open, it will open.

3: Insert the thread tip into the thread stopper and press the switch.

* If excessive force is applied to the thread stopper, it may be damaged.
* Holding the line changer and guiding the thread with the other hand will stabilize the winding.
* At that time, please use gloves to prevent injury.
* If you use the pincushion mark line as a guide, troubles such as color and deformation will be reduced.

4: When the thread is full at the bobbin mark line position, remove the wound thread.

If you move the spool in the opposite direction of 2: (about 5 mm), the thread will come off in a cohesive state.

* If there are many threads to be pulled out, they cannot be pulled out all at once, so repeat the same operation.

-