DAIWA PE Line Changer

Line changer with interchangeable PE line

Unique structure that allows winding of PE line with soft thread itself.
* If you use it for nylon fine thread, the thread will shrink strongly and the wound thread will not come off, so please do not use it.
Since the take-up method is used instead of the pull-out method, the wound threads are grouped together and it is easy to clean up.

■ When the spool arm is deployed

Body dimensions : 47mm x 50mm x 150mm (height)

Body weight : Approximately 95g (excluding batteries)

Specification : Batteries: 2 AA batteries
* AA batteries are not included.
Length that can be pulled out at one time: Approximately 150m (PE line No. 1)

Winding method :

1: Insert AA batteries correctly according to the instructions on the main unit.

2: Push the spool in the direction of the arrow until you hear a click, and the spool arm will open.

* Close the spool arm when not in use.
If you leave it open, it will open.

3: Insert the thread tip into the thread stopper and press the switch.

* If excessive force is applied to the thread stopper, it may be damaged.
* Holding the line changer and guiding the thread with the other hand will stabilize the winding.
* At that time, please use gloves to prevent injury.
* If you use the pincushion mark line as a guide, troubles such as color and deformation will be reduced.

4: When the thread is full at the bobbin mark line position, remove the wound thread.

If you move the spool in the opposite direction of 2: (about 5 mm), the thread will come off in a cohesive state.

* If there are many threads to be pulled out, they cannot be pulled out all at once, so repeat the same operation.

-