DAIWA 20 Kohga MX Air Portable N69MB TG AP

Introducing a 2-piece high-sensitivity tie rubber rod with excellent portability.

The standard model is equipped with a high-sensitivity metal top and has good bite. The spinning model has a mega-top specification in consideration of the cast and realizes good bite. The TG model has achieved the ultimate bend that can only be achieved with a full solid thrill game. The blanks have power due to the effect of the optimum structure X45 against twisting, and by adopting a V joint even though it is 2 pieces, beautiful bending and power loss are reduced. You can enjoy interacting with the big die with confidence. In addition, an air sensor seat (slim trigger) is used for the reel seat to achieve both weight reduction and ease of grip. The degree of freedom of grip has also increased, enabling comfortable retrieval.

Kohga MX Air Portable N69MB TG AP

It bends and sticks, and a large die floats. "THRILL GAME" blank specification standard rod. The 6'9 inch length is set with consideration for automatic hooking when winding for free. A semi-long model that can be used with a Tairaba of around 250g in the DoTERRA sink.

Air sensor sheet (slim trigger)

*** ■ About the temperature change of the metal top.

Due to the characteristics of the material of superelastic titanium alloy, the elasticity of the superelastic titanium alloy decreases in a low temperature environment of 5 ° C or less, and the return of the tip of the tip becomes slow. Due to the extreme cold in the early morning and at night and the influence of the wind, a noticeable bend may occur. Furthermore, in an environment of 0 ° C or lower, the decrease in elasticity progresses further, causing a phenomenon in which the tips of the tips remain bent and do not return. In either case, if the temperature rises, it will return to its original superelasticity and can be used normally.

■ Please avoid using it that causes excessive bending.
The metal top can be used comfortably in normal operation, but excessive bending due to external factors such as entanglement and thread entanglement at the tip may leave habit (plastic deformation) or damage due to metal fatigue.

■ You can correct any habits by hand.
If a habit remains as in 2, you can correct it by slowly bending it in the direction opposite to the curved side. However, repeated correction of habits may cause metal fatigue, so avoid operations that leave habits such as entanglement.

Please be sure to read the instruction manual for comfortable use.