ABU GARCIA Revo 5 Winch

Equipped with 8+1 bearings. Model compatible with deep cranks and magnum cranks. Max drag force of 11kg and line capacity of 20lb-120m make it the perfect spec for big lakes and big fish.
Ergonomic design that is easy to grip despite the 35mm spool. Asymmetrical clutch and offset thumb rest allow for a deep grip, allowing for powerful fights with big fish! Equipped with IVCB6 centrifugal brake system that works well with thick lines.

Ergonomic Design
By offsetting the thumb rest toward the handle arm, you can grip deeper and stronger during a fight, preventing the dispersion of force and achieving strong and stable winding. The clutch bar has an asymmetrical design to prevent accidental interference with the palm of the hand and "pushing" when palming.

High-strength durametal frame and crank side plates
The aluminum alloy durametal frame and crank side plates provide the toughest and most precise gearing support, making them ideal for big bait fishing in FW and SW, or when the stiffest fishing is required.

IVCB6 Brake System
Equipped with the IVCB6 brake system, which is compatible with the newly developed 35mm spool. With a single adjustment dial on the outside, it can be easily adjusted to suit various conditions such as tailwinds and headwinds.

Power Stack Carbon Matrix Drag
By using a large carbon washer with a key on the outer diameter, it is possible to enlarge the drag friction surface. This washer configuration provides three friction surfaces, achieving not only maximum drag force, but also smooth start-up performance and durability.

Duragear Gear System
Equipped with a strong large diameter brass gear. With increased durability and strength, the strong gear allows you to fight with big fish with confidence.

95mm crank-shaped handle & large handle knob
Equipped with a large handle knob and a 95mm crank-shaped 3mm thick aluminum handle that allows for powerful winding and forceful fighting with big fish.

Gullwing & Camlock Lever
The camlock lever for opening the palm side plate is located at the bottom of the side plate. When the camlock lever is in the "open" position, the claw of the lever protrudes, so it is designed to prevent you from forgetting to tighten the lever. It has a gullwing mechanism that makes it easy to replace and check the spool without removing the side plate.

Pinion support structure
The powerful winding force of the handle is transmitted in the order of drive gear → pinion gear → spool. Even the slightest distortion in each part of this rotation transmission will have a negative effect on the rotation.
The pinion support structure reliably supports the outer part of the pinion gear with the crank side plate via a ball bearing. This structure has achieved highly efficient winding and a significant improvement in gear feel. Furthermore, when casting, optimal spool free and castability have been achieved by maintaining a constant appropriate clearance between the inner surface of the pinion gear and the rotating spool shaft.

35mm diameter spool
Outer diameter 35mm, width 22mm spool. Large capacity line capacity of 20lb-120m, PE3-160m. Line capacity that can handle fishing where you cast and reel in deep cranks and other lures.